![]() ![]() I was prompted to enter the password, which I was then able to use to log in to the iDRAC web interface. The username I configured corresponds with ID 2, so then I used ipmitool to set the password for that user: $ sudo ipmitool user set password 2 ID Name Callin Link Auth IPMI Msg Channel Priv Limit I spent some time trying to determine what the various raw hex values for ipmi meant, but that was not productive.Įventually though I did hit upon an ipmitool command that worked: $ sudo ipmitool user list 1 ![]() # ipmitool raw 0x3c 0x40īut that did not work for me, and produced an error code. Be aware that this will wipe any existing settings on the BMC that you may have set from the web interface, but excludes network settings. …you can reset the BMC to factory defaults with IPMICFG or ipmitool. The command was successful, but that did not reset the password for me. Reset BMC/DRAC to default: $ sudo ipmitool mc reset cold But I thought I’d see what I could do via ipmitool first.įrom Configuring DRAC with ipmitool and ipmitool Cheatsheet: I figured I was stuck and would have to go to the data center, reboot the server, and boot into the Lifecycle Controller in order to reset the iDRAC password. (For reasons that aren’t clear to me, submitting just the first 20 characters of the password saved in the password manager did not work either.) Then later, when I attempting to log it using the password saved in my password manager, it didn’t match. The password field on the iDRAC web interface truncates the password at 20 characters, and so I submitted a partial password. Continue with Step 5: Setting a new password (IPMI). Back in the KVM window, select the shutdown option Restart via the Windows 'Start' button on the bottom left. The problem? The password can contain at most 20 characters, a limitation that is not obvious from the web interface. First, change the netboot back to Boot from the hard disk in your OVHcloud Control Panel (see step 1). I did so by generating a random password in my password manager and pasting it into the password field. When you log into the iDRAC web interface as root/calvin, it warns you that you are using the default username/password and prompts you to change the password. However, I ran into a problem, which I blame on poor user interface design: In the previous post, I configured the iDRAC interface on a Dell server using ipmitool on CentOS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |